Luthiers: Fret slot depth cutting question
Luthiers: Fret slot depth cutting question
Fret slotting saw giving a kerf of inches, for cutting fret slots in a guitar fingerboard Complete with a perspex guide to control the depth
Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough!Not sure if your fret slots are IF you are about to take on a refret job of a fretted instrument, you should be checking the depth of the fret slots Still a good idea to check the fret slot
chili slot machine The laser-cut Acrylic depth stop should be adjusted to cut a slot that is just slightly deeper than the tang of the frets Fret slots which are too deep weaken Throughout this article I will be using a diameter endmill to cut the fret slots The width of this cutter determines the width of the slot