Plug welds and slot welds are identified by the same symbol, except

Click the Welding Sym-Slot-Plug tool from the DimsNotes tool set · Click to place the object in the drawing, and click again to set the rotation · Once the

Plug welds and slot welds are identified by the same symbol, except The suggestions I did find were changing the pulse profile , using a larger hole and using a slot instead of a hole; I

Click the Welding Sym-Slot-Plug tool from the DimsNotes tool set · Click to place the object in the drawing, and click again to set the rotation · Once the

slot bonus no deposit Slot or Plug Weld · Width or diameter of slot should not be less than three times the thickness of the part in which slot is formed or 25 mm,

So it's a slot & tab assembly ? the weld cap instruction over top of the symbol No sin in adding words in a note next to the weld, main point

slot garagedeur - Slot welds are typically used in lap joints where the fillet weld length is limited Plug Welds:

welded joints such as Butt weld, Fillet weld, Plug weld, Slot weld is discussed weld